Threshold Door Seal - Low Profile, Part M
For inward or outward opening doors
Why Draught Proof?
Your house or commercial property will lose heat during cold weather partly due to poor thermal insulation, but also due to the air-leakiness of the building. This warm air loss is technically known as infiltration or permeability and is measured in metres cubed per hour per square metre of floor area. A typical building built 1900 to 1990 will lose around 20-30 metres cubed of air per hour per square meter of floor area. This is due to natural leakage through the fabric of the building, but largely through gaps around windows and doors. Good use of draft proofing could reduce your air permeability to around 8-10 metres cubed per hour which is a good low cost way of reducing you heating bills. The amount of air infiltration to your property will also depend on its exposure to wind so if you are on a hillside or near the coast then it is even more beneficial for you have good draught proofing.
- Stormguard CDX Compression Draught Excluder Threshold Weather & Water Seal
- For inward or outward opening doors
- Low profile with concealed fixings
- Central Nitrile rubber seal
- Easy access for light wheeled traffic only 17mm floor to door clearance, up to 3mm tolerance
- Also easy access for prams
- Part-M Regulation Building Regulations Compliant for Wheelchair access to BS8300
- Aluminium and nitrite construction to BS EN-1474
- Available is 838mm, 914mm and 1219mm length