450w Mono Solar Panel Kit With 35A Victron Smart Charge Controller, Battery Monitor, Inverter and Mounting Brackets

• Battery voltage 12 / 24 / 48V Auto Select (software tool needed to select 36V)
• Rated charge current 35A
• Nominal PV power 1a, b) 12V: 500W / 24V: 1000W / 36V: 1500W / 48V: 2000W
• Max. PV short circuit current 2) 40A
• Maximum PV open circuit voltage 150V absolute maximum coldest conditions
• 145V start-up and operating maximum
• Maximum efficiency 98%
• Self-consumption 12V: 20mA 24V: 15mA 48V: 10mA
• Charge voltage ‘absorption’ Default setting: 14,4 / 28,8 / 43,2 / 57,6V (adjustable)
• Charge voltage ‘float’ Default setting: 13,8 / 27,6 / 41,4 / 55,2V (adjustable)
• Charge algorithm multi-stage adaptive (eight pre-programmed algorithms)
• Temperature compensation -16 mV / -32 mV / -64 mV / °C
• Protection
• PV reverse polarity
• Output short circuit
• Over-temperature
• Operating temperature -30 to +60°C (full rated output up to 40°C)
• Humidity 95%, non-condensing
• Data communication port VE.Direct

ENCLOSURE

• Colour Blue (RAL 5012)
• Power terminals 16 mm² / AWG6
• Protection category IP43 (electronic components), IP22 (connection area)
  Weight 1,25 kg
• Dimensions (h x w x d) 130 x 186 x 70 mm

STANDARDS

• Safety EN/IEC 62109-1, UL 1741, CSA C22.2

1a) If more PV power is connected, the controller will limit input power.
1b) The PV voltage must exceed Vbat + 5V for the controller to start.
Thereafter the minimum PV voltage is Vbat + 1V.
2) A PV array with a higher short circuit current may damage the controller.

Victron Energy Inverter

Technical Specification

• 12 Volt
• Cont. power at 25°C (1) 1200VA
• Cont. power at 25°C / 40°C 1000 / 850W
• Peak power 2200W
• Output AC voltage / frequency (adjustable) 230VAC or 120VAC +/- 3% 50Hz or 60Hz +/- 0,1%
• Input voltage range 9,2 – 17V
• DC low shut down (adjustable) 9,3V
• Dynamic (load dependent) DC low shut down (fully configurable)
• DC low restart and alarm (adjustable) 10,9 V
• Battery charged detect (adjustable) 14,0V
• Max. efficiency 91%
• Zero-load power 6,5W
• Default zero-load power in ECO mode (default retry interval: 2,5 s, adjustable) 1
• ECO mode stop and start power setting Adjustable
• Protection (2) a – f
• Operating temperature range -40 to +65°C (fan assisted cooling) Derate 1,25% per °C above 40°C
• Humidity (non-condensing) max 95%

ENCLOSURE

• Material & Colour Steel chassis and plastic cover (blue Ral 5012)
• Battery-connection Screw terminals
• Maximum cable cross-section 25 10mm² /AWG4
• Standard AC outlets UK (BS 1363)
• Protection category IP 21
• Weight 5.5kg
• Dimensions (hxwxd, mm) 105 x 230 x 325

ACCESSORIES

• Remote on-off Yes
• Automatic transfer switch Filax

STANDARDS

• Safety EN-IEC 60335-1 / EN-IEC 62109-1
• EMC EN 55014-1 / EN 55014-2 / IEC 61000-6-1 / IEC 61000-6-2 / IEC 61000-6-3
• Automotive Directive ECE R10-4

1) Nonlinear load, crest factor 3:1
2) Protection key:
a) output short circuit
b) overload
c) battery voltage too high
d) battery voltage too low
e) temperature too high

f) DC ripple too high

Flip mounts

Tilt your panels towards the sun to achieve optimal power generation. More generated wattage will be achieved compared to panels laid flat. Allows for mounting onto curved boat roofs. Arrowhead design to ‘hook’ the raised panel in place and stop it dropping down with vibration or high winds. Adjustable height and solar panel angle. Solar panels can be laid flat when not in use by sliding to the bottom. Max 36 degrees tilt. 240 x 240 x 240mm